This 1/4 inch thick (6mm) rotating template allows you to quiltÂ stunning designs easily without marking!
Just insert the center anchor device with its secure pin system into the center of the desired design area and stitch with your ruler foot against the curved edge until you reach the end. Then rotate the template for the next pass. Three passes complete the basic 3-point Celtic knot design. Clearly marked lines not only allow you to keep everything lined up easily, but also allow you to stitch a second design off-set from the first for a 6 point Celtic knot design. Below see not only the 6 point 12" design, but also the 9" version within it.
There are additional markings at 1/4, 1/2, and 3/4 inches along the edges so that you can use the straight side and the half circle side for other ruler work. Markings are in green and a gold metallic that shows up very well under the machine. The template stitches a 12 inch half circle, and the design measures 13.75 inches from point to opposite point on the 6 point design. Perfect for a 14 inch block. Use the half circle side to stitch from corner to corner around a 12 inch block and create a square Celtic knot as well with this template.
This is a 1/4 inch thick template originally designed for long arm use, but can be used on a domestic machine. There are smaller sizes of this product available as well: Â 9 inch, 6 inch, and a pinless 3 inch version. Comes with center pin and instructions.